510/710 F
Single direction thrust ball bearingSingle direction thrust ball bearings can accommodate axial loads in one direction. They must not be subjected to any radial load. Their separable components facilitate mounting/dismounting and maintenance inspections. Many of the components are interchangeable. The shaft washers have a ground bore that enables an interference fit.
- Separable design facilitates mounting/dismounting and maintenance inspections
- Interchangeable components
- Ground bore of shaft washers enable interference fit
Description
Dimensions
| d | 710 mm | Bore diameter |
|---|---|---|
| D | 780 mm | Outside diameter |
| H | 53 mm | Height |
| d1 | ≈ 779 mm | Outside diameter shaft washer |
| D1 | ≈ 712 mm | Inner diameter housing washer |
| r1,2 | min. 1.5 mm | Chamfer dimension washer |
Abutment dimensions
| da | min. 746 mm | Abutment diameter shaft |
|---|---|---|
| Da | max. 734 mm | Abutment diameter housing |
| ra | max. 1.5 mm | Fillet radius |
Calculation data
| Basic dynamic load rating | C | 358 kN |
|---|---|---|
| Basic static load rating | C0 | 2 850 kN |
| Fatigue load limit | Pu | 39 kN |
| Reference speed | 600 r/min | |
| Limiting speed | 850 r/min | |
| Minimum load factor | A | 42 |
Mass
| Mass bearing (including seat washer where applicable) | 28 kg |
Tolerances and clearances
Bearing data
Bearing interfaces
