PCZ 1414 M
POM composite straight bushing, inch sizeSKF POM composite straight (cylindrical) bushings, inch sizes, are suitable for oscillating, rotating and linear movements, and can accommodate radial loads. After initial grease fill, they are optimized for minimal maintenance under tough operating conditions. Pockets in the sliding surface serve as grease reservoirs. Relubrication can extend bearing service life considerably. Despite their compact design, they can accommodate heavy loads.
- Cost-effective with long service life
- Very good frictional properties
- High load carrying capacity
- High sliding velocity
Description
| Material | POM composite |
| Operating temperature | min. -40 °C |
| Operating temperature | max. 110 °C |
Dimensions
| d | 22.225 mm | Bore diameter |
|---|---|---|
| D | 25.4 mm | Outside diameter |
| B | 22.225 mm | Width |
| M | 4 mm | Diameter lubrication hole |
| c1 | min. 0.1 mm | Length chamfer bore – axial direction |
| c1 | max. 0.7 mm | Length chamfer bore – axial direction |
| c2 | min. 0.2 mm | Length chamfer outside diameter – axial direction |
| c2 | max. 1 mm | Length chamfer outside diameter – axial direction |
Recommended fits
| Shaft diameter range | min. 21.913 mm |
| Shaft diameter range | max. 21.943 mm |
| Housing bore range | min. 25.4 mm |
| Housing bore range | max. 25.42 mm |
Calculation data
| Basic dynamic load rating, radial direction | C | 57 kN |
|---|---|---|
| Basic static load rating, radial direction | C0 | 120 kN |
| Specific dynamic load factor | K | 120 N/mm² |
| Specific static load factor | K0 | 250 N/mm² |
| Factor depending on material and bearing type | KM | 1 900 |
| Permissible sliding velocity | v | max. 2.5 m/s |
| Coefficient of friction | µ | min. 0.02 |
| Coefficient of friction | µ | max. 0.2 |
Mass
| Mass bushing | 0.017 kg |
Tolerances and clearances
Bushing data
Design of bushing arrangements
