PCZ 0708 M
POM composite straight bushing, inch sizeSKF POM composite straight (cylindrical) bushings, inch sizes, are suitable for oscillating, rotating and linear movements, and can accommodate radial loads. After initial grease fill, they are optimized for minimal maintenance under tough operating conditions. Pockets in the sliding surface serve as grease reservoirs. Relubrication can extend bearing service life considerably. Despite their compact design, they can accommodate heavy loads.
- Cost-effective with long service life
- Very good frictional properties
- High load carrying capacity
- High sliding velocity
Description
| Material | POM composite |
| Operating temperature | min. -40 °C |
| Operating temperature | max. 110 °C |
Dimensions
| d | 11.113 mm | Bore diameter |
|---|---|---|
| D | 13.494 mm | Outside diameter |
| B | 12.7 mm | Width |
| M | 3 mm | Diameter lubrication hole |
| c1 | min. 0.1 mm | Length chamfer bore – axial direction |
| c1 | max. 0.6 mm | Length chamfer bore – axial direction |
| c2 | min. 0.2 mm | Length chamfer outside diameter – axial direction |
| c2 | max. 1 mm | Length chamfer outside diameter – axial direction |
Recommended fits
| Shaft diameter range | min. 10.828 mm |
| Shaft diameter range | max. 10.853 mm |
| Housing bore range | min. 13.495 mm |
| Housing bore range | max. 13.513 mm |
Calculation data
| Basic dynamic load rating, radial direction | C | 17 kN |
|---|---|---|
| Basic static load rating, radial direction | C0 | 35.5 kN |
| Specific dynamic load factor | K | 120 N/mm² |
| Specific static load factor | K0 | 250 N/mm² |
| Factor depending on material and bearing type | KM | 1 900 |
| Permissible sliding velocity | v | max. 2.5 m/s |
| Coefficient of friction | µ | min. 0.02 |
| Coefficient of friction | µ | max. 0.2 |
Mass
| Mass bushing | 0.0035 kg |
Tolerances and clearances
Bushing data
Design of bushing arrangements
