GAC 110 F
Angular contact spherical plain bearing, maintenance-free, metric sizesAngular contact spherical plain bearings are designed to accommodate combined radial and axial loads. Single bearings can accommodate axial loads acting in one direction. This specific design includes a steel/PTFE FRP sliding contact surface combination that is maintenance-free. However, relubrication, which can be applied from both sides, can extend bearing service life.
- Designed for combined radial and axial loads
- Separable inner and outer rings enable easier mounting
- Long service life and maintenance-free
- Relatively insensitive to contaminants
- Low coefficient of friction
Description
Sliding contact surface combination | Steel/PTFE FRP |
Material, inner ring | Bearing steel |
Material, outer ring | Bearing steel |
Relubrication feature | Without |
Sealing | Without |
Dimensions
d | 110 mm | Bore diameter |
---|---|---|
D | 170 mm | Outside diameter |
T | 38 mm | Width |
α | 3 ° | Angle of tilt |
dk | 155 mm | Raceway diameter inner ring |
B | 38 mm | Width inner ring |
C | 34 mm | Width outer ring |
r1 | min. 2.5 mm | Chamfer dimension bore/large side face |
r2 | min. 0.6 mm | Chamfer dimension bore/small side face |
s | 13 mm | Distance sphere diameter centre – large inner ring side face |
Abutment dimensions
da | max. 124 mm | Abutment diameter shaft, small inner ring side face |
---|---|---|
db | max. 145 mm | Abutment diameter shaft, large inner ring side face |
Da | min. 130 mm | Abutment diameter housing, large outer ring side face |
Db | min. 156 mm | Abutment diameter housing, small outer ring side face |
ra | max. 2.5 mm | Fillet radius shaft, housing |
Calculation data
Basic dynamic load rating | C | 220 kN |
---|---|---|
Basic static load rating | C0 | 345 kN |
Specific dynamic load factor | K | 50 N/mm² |
Specific static load factor | K0 | 80 N/mm² |
Material constant | KM | 480 |
Mass
Mass plain bearing | 3.7 kg |