BTW 200 CM/SP
Double direction angular contact thrust ball bearing, super-precision, basic designDouble direction angular contact thrust ball bearings are designed to locate spindle shafts axially in both directions. These bearings are intended for mounting in combination with cylindrical roller bearings, and consist of two single row angular contact thrust ball bearings arranged back-to-back. The large number of balls enables these bearings to accommodate high axial loads in both directions and provides a high degree of system rigidity.
- Accommodate high axial loads in both directions
- Offer maximum load carrying capacity and maximum system rigidity
- Available for shaft diameters from 35 to 200 mm
- Available with either steel or ceramic balls
- Separable
Description
Dimensions
| d | 200 mm | Bore diameter |
|---|---|---|
| D | 310 mm | Outside diameter |
| H | 132 mm | Height |
| d1 | 263.9 mm | Shoulder diameter shaft washer (high shoulder) |
| 2C | 66 mm | Height of both housing washers |
| r1,2 | min. 2.1 mm | Shaft washer chamfer radius |
| r3,4 | min. 1 mm | Housing washer small chamfer radius |
Abutment dimensions
| da | min. 236 mm | Abutment diameter shaft |
|---|---|---|
| Da | min. 291 mm | Abutment diameter shaft |
| Da | max. 292 mm | Abutment diameter housing |
| ra | max. 2 mm | Fillet radius |
| rb | max. 1 mm | Fillet radius |
Calculation data
| Basic dynamic load rating | C | 238 kN |
|---|---|---|
| Basic static load rating | C0 | 865 kN |
| Fatigue load limit | Pu | 25.5 kN |
| Attainable speed for grease lubrication | 1 900 r/min | |
| Attainable speed for oil-air lubrication | 2 400 r/min | |
| Contact angle | α | 60 ° |
| Preload | 1 525 N | |
| Static axial stiffness | 1 395 N/µm | |
| Reference grease quantity | Gref | 157.1 cm³ |
Mass
| Mass bearing | 30.9 kg |
Tolerances and clearances
Bearing data
- Tolerances: P4C, SP, UP
Principles of bearing selection and application
- Chamfer dimensions
- Seat tolerances for standard conditions: shafts, housings
- Values for ISO tolerance classes: shafts, housings
- Speed dependent initial grease fill → Initial grease fill
