53314
Single direction thrust ball bearing with sphered housing washerSingle direction thrust ball bearings, with sphered housing washer, can accommodate axial loads in one direction. They must not be subjected to any radial load. Many of the components are interchangeable. The shaft washers have a ground bore that enables an interference fit. The sphered housing washers can accommodate initial misalignment when configured correctly with a sphered seat washer or a machine component with a sphered surface.
- Separable design facilitates mounting/dismounting and maintenance inspections
- Interchangeable components
- Ground bore of shaft washers enables interference fit
- Sphered housing washers can accommodate initial misalignment
Description
Dimensions
| d | 70 mm | Bore diameter |
|---|---|---|
| D | 125 mm | Outside diameter |
| H | 44.2 mm | Height |
| H1 | 48 mm | Height bearing including seat washer |
| d1 | ≈ 125 mm | Outside diameter shaft washer |
| D1 | ≈ 72 mm | Inner diameter housing washer |
| D2 | 98 mm | Inner diameter sphered seat washer |
| D3 | 130 mm | Outside diameter sphered housing washer |
| C | 13 mm | Height sphered housing washer |
| R | 100 mm | Radius sphered housing washer |
| s | 43 mm | Centre height housing washer sphere |
| r1,2 | min. 1.1 mm | Chamfer dimension washer |
Abutment dimensions
| da | min. 103 mm | Abutment diameter shaft |
|---|---|---|
| Da | max. 98 mm | Abutment diameter housing |
| ra | max. 1 mm | Fillet radius |
Calculation data
| Basic dynamic load rating | C | 135 kN |
|---|---|---|
| Basic static load rating | C0 | 320 kN |
| Fatigue load limit | Pu | 11.8 kN |
| Reference speed | 1 800 r/min | |
| Limiting speed | 2 600 r/min | |
| Minimum load factor | A | 0.53 |
Mass
| Mass bearing (including seat washer where applicable) | 2.5 kg |
Associated products
| Seat washer | U 314 |
Tolerances and clearances
Bearing data
Bearing interfaces
