PCM 15015560 M
POM composite straight bushingSKF POM composite straight (cylindrical) bushings are suitable for oscillating, rotating and linear movements, and can accommodate radial loads. After initial grease fill, they are optimized for minimal maintenance under tough operating conditions. Pockets in the sliding surface serve as grease reservoirs. Relubrication can extend bearing service life considerably. Despite their compact design, they can accommodate heavy loads.
- Cost-effective with long service life
- Very good frictional properties
- High load carrying capacity
- High sliding velocity
Description
| Material | POM composite |
| Operating temperature | min. -40 °C |
| Operating temperature | max. 110 °C |
Dimensions
| d | 150 mm | Bore diameter |
|---|---|---|
| D | 155 mm | Outside diameter |
| B | 60 mm | Width |
| M | 8 mm | Diameter lubrication hole |
| c1 | min. 0.2 mm | Length chamfer bore – axial direction |
| c1 | max. 1 mm | Length chamfer bore – axial direction |
| c2 | min. 0.8 mm | Length chamfer outside diameter – axial direction |
| c2 | max. 1.6 mm | Length chamfer outside diameter – axial direction |
Recommended fits
| Tolerance shaft | h8 |
| Tolerance housing | H7 |
Calculation data
| Basic dynamic load rating, radial direction | C | 1 060 kN |
|---|---|---|
| Basic static load rating, radial direction | C0 | 2 200 kN |
| Specific dynamic load factor | K | 120 N/mm² |
| Specific static load factor | K0 | 250 N/mm² |
| Factor depending on material and bearing type | KM | 1 900 |
| Permissible sliding velocity | v | max. 2.5 m/s |
| Coefficient of friction | µ | min. 0.02 |
| Coefficient of friction | µ | max. 0.2 |
Mass
| Mass bushing | 0.5 kg |
Tolerances and clearances
Bushing data
Design of bushing arrangements
